This product provides a wired solution for routing
IR commands from different locations within a home
back to a central point where the equipment to be
controlled is located. This will then permit such
equipment as a video recorder, satellite receiver and
Hi-fi system etc., to be controlled from various
remote locations. This is achieved by firing the
original equipment's remote control handset
(pre-programmed or learning equivalent) at a suitably
positioned WM22 IR Sensor. The command codes are
routed via a wired link to the Roomlink Driver
(normally located next to
the source equipment) and in turn, to an IR
Emitter which "repeats" the codes enabling the source
equipment to receive and respond to those commands.
We recommend that each WM22 is wired back to the
Roomlink Driver using simple four core telephone wire
or screened Cat5 cable with the drain wire connected
to the screen terminal. If that is inconvenient, or
more than four IR Sensors (WM22) are required, it is
possible to daisy chain extra Sensors.
NOTE: A very small number of manufacturers
codes will not pass through the IR link. Always test
the operation before specifying.
1 x Roomlink Driver
2 x Standard IR Flood Emitters (SL-FE) -2 x
Window Emitters pack (SL-DE)
1 x 12 volt plug-top power supply (M12V DC
1amp - UK only)
